Fan SHIM for Raspberry Pi T:Fan Shim for Raspberry Pi a switch-controlled input power terminal

a switch-controlled input power terminal block

Includes a 16x3 character LCD display

Screw hole diameter: 2mm

It’s a simple kit to make and should take around 5-15 minutes to make depending on your soldering ability

check out the CHARGER DOCTOR

Fan SHIM for Raspberry Pi T:Fan Shim for Raspberry Pi a switch-controlled input power terminalMake your Raspberry Pi 4 seriously cool with Fan SHIM! This 30mm no solder, controllable CPU fan with RGB LED and tactile switch will give your Raspberry Pi significantly better thermal performance. It's whisper quiet too! Fan SHIM uses a friction fit header, so it just slips onto your Pi's pins and it's ready to go, no soldering required! Note that, due to the height of the fan, if you want to use HATs or pHATs with Fan SHIM, then you'll need to use