SparkFun Top pHAT for Raspberry Pi _ws10 you can cut its trace

you can cut its trace with a knife and then run a wire from the lower hole to a new GPIO pin

The power requirements depend a little on how much of the display is lit but on average the display uses about 20mA from the 3

This listing is for the micro:bit CLUB Pack

2 x Green 10mm LED

01uA (almost none) Viewing Angle >170°

SparkFun Top pHAT for Raspberry Pi _ws10 you can cut its traceFeeling fancy? Why not add a Top pHAT to your Pi pHAT stack? The SparkFun Top pHAT for Raspberry Pi is intended to be at the top of a pHAT stack so you won't find any pins for stacking on top of this board, but that's ok because you will want to preserve your view of the 2. 4" TFT display, six RGB LED's and three switches squeezed onto this board! Can you use the SparkFun Top pHAT to prototype machine learning on your Raspberry Pi 4, NVIDIA Jetson,