Grove - I2C Motor Driver with L298 _RaspberryPi The module can be configured

The module can be configured either by using the serial interface or by scanning command barcodes found in the Settings Manual

Button harness

Best performance when mounted in an enclosed cabinet

it works but we're not going to replace our goPro or cellphone camera here

The guide starts with an introduction to using a micro:bit and the MakeCode editor

Grove - I2C Motor Driver with L298 _RaspberryPi The module can be configuredThe Grove I2C Motor Driver uses the popular motor driver chip L298. In order to use the Grove interface to let a microcontroller like an Arduino control the Motor Driver, the I2C Grove interface is included. There is also an ATmega8L chip on board to enable the I2C connection. You can also use this dual channel motor driver to connect with a stepper motor which means you can control two motors at a time. The Arduino Library of this board is also