Tormek Turning Tool Setter ORMD The Fine cut surface provides

The Fine cut surface provides very light abrasion useful for maintaining an edge with a hint of tooth

I began with a knife that was already very sharp

Fine Grit: Norton Part No

then see the Tormek MSK-250 Stainless Steel Shaft

This stone is faster than the Norton Coarse Alundum Sickle and Scythe Stone and leaves a rougher edge

Tormek Turning Tool Setter ORMD The Fine cut surface providesThe TTS 100 Turning Tool Setter allows for instant replication of the geometries on turning gouges and skews when using the SVD 186 Gouge Jig and the SVS 50 Multi Jig. With built in edge geometries. Works on any stone diameter. Made in Sweden. Q. Is this jig compatible with any model Tormek Sharpener? A. Yes. This jig will work with both the Tormek T8, the Tormek T4 as well as older models like the T7, T3 and 2000.