2 link DIY Axle Brackets (4 pieces) Size:3" Standoff These fittings will allow you

These fittings will allow you to tie our accumulators into the system with a 3/8” NPT male on one side and a #8 ORB on the other side to go into accumulator

Misc parts to help get your brake pedal setup to your booster/master

These brackets are lower profile to get the bag closer to the axle

check our other brake components for fittings

PLEASE NOTE that in some cases you will have to cut out the spare tire well from the trunk and weld in a flat piece of sheetmetal to allow space for bag or cylinder and coil

2 link DIY Axle Brackets (4 pieces) Size:3" Standoff These fittings will allow youFor those of you making your own 2 link, these brackets are used to bolt to the link bars and weld on to the axle. Slotted so you can adjust axle front to back. The short brackets have a standoff of 3" from the bottom of the axle to the center of mounting bolts. The tall brackets have a standoff of 5" from the bottom of the axle to the center of mounting bolts. (EACH SET COMES WITH 4 PIECES)